Ruby PSGS2112C POE

PSGS-2112C
12-Port Managed PoE GbE Switch with 2 SFP Dual Media

PSGS-2112C supports 12 10/100/1000Mbps Auto-negotiation, Auto-MDIX Ethernet ports and Power over Ethernet to IEEE 802.3af compliant devices. It’s fully compliant with the standards of IEEE 802.3/u/x/z/ab/af. It is equipped with 12 Giga TP ports and 2 of which are dual media ports that accommodate optional 10/100/1000Base-T or SFP modules. In addition, the switch implements the QoS (Quality of Service), Mac Filtering Policy, Port Mirror, VLAN and full L2 protocol. The overall network management is enhanced and the network efficiency is also improved to accommodate high bandwidth applications with security.

Key Features

PoE Save Your Power Infrastructure Cost
12-PoE ports allow power to be supplied to end devices, such as Wireless Access Points or VoIP Phones, directly through the existing LAN cables. By supplying the power mid-span, you can centralize power distribution and backup without the need to increase infrastructure.
2 Dual Media for Flexible Fiber Connection
11, 12 dual media port are provided for flexible fiber connection. You can select to install optional transceiver modules in these slots for short, medium or long distance fiber backbone attachment. Use of the SFP will disable their corresponding built-in 10/100/1000Base-T connections.
QoS support layer 4 classification
The switch supports not only Layer 2 802.1p Priority Queue control, but also supports programmable higher layer classification and prioritization to enable enhanced Quality of Service (Qos) support for real time applications base on information taken from Layer 2 to Layer 4, such as VoIP.
Q-in-Q VLAN for performance & security
The VLAN feature in the switch offers the benefits of both security and
performance. VLAN is used to isolate traffic between different users and thus provides better security. Limiting the broadcast traffic to within the same VLAN broadcast domain also enhances performance. VLAN support enabling advanced techniques such as „802.1Q-in-1Q“ to be deployed.
802.3ad Port Trunk for Bandwidth Aggregation
The Gigabit ports can be combined together to create a multi-link loadsharing trunk. Up to 6 Gigabit ports can be set up per trunk for bandwidth up to 12Gbps, all traffic is aggregated based on MAC addresses, thus balancing the traffic load. The switch supports up to 6 trunking groups. Port trunks are useful for switch-to-switch cascading, providing very high full-duplex speeds.
802.1x Access Control Improve Network Security
802.1x features enable user authentication for each network access attempt. Port security features allow you to limit the number of MAC addresses per port in order to control the number of stations for each port. Static MAC addresses can be defined for each port to ensure only registered machines are allowed to access. By enabling both of these features, you can establish an access mechanism based on user and machine identities, as well as control the number of access stations.
802.1d Compatible & 802.1w Rapid Spanning Tree
For mission critical environments with multiple switches supporting STP, you can configure the switches with a redundant backup bridge path, so transmission and reception of packets can be guaranteed in event of any failover switch on the network.
Broadcast/Multicast Storm Control
To limit too many broadcast/multicast flooding in the network, broadcast/ multicast storm control is used to restrict excess traffic. Threshold values are available to control the rate limit for each port. Packets are discarded if the count exceeds the configured upper threshold.
Technical Specification
Standard Compliance
n IEEE 802.3 10Base-T
n IEEE 802.3u 100Base-TX
n IEEE 802.3x Flow Control Capability
n IEEE 802.3z 1000Base-X Ethernet
n IEEE 802.3ab 1000Base-TX
n ANSI/IEEE 802.3 Auto-negotiation
n IEEE 802.1q VLAN
n IEEE 802.1d Spanning Tree Protocol.
n IEEE 802.1w Rapid Spanning Trees
n IEEE 802.1x Port-based network access control
n IEEE 802.1p Class of Service
n IEEE 802.3af Power over Ethernet
n IEEE 802.3ad Link Aggregation Control Protocol (LACP)
RoHS Compliance
PoE Specification
n Supports IEEE 802.3af compliant
n Supports Power over Ethernet (PSE) on each Gigabit UTP port
n Full power support for per POE port
n Auto detect powered device and consumption levels
n Supports per port power consumption monitoring
n Smart feature for PD on/off, PD detection, power level, PD status and power feeding priority
n Circuit protection to prevent power interference between ports
n Supports per port PoE State setting
n Supports per port power priority setting
n LED indicators for POE ready and POE activity
Performance
Switching capacity:
n 12 Gigabit Ethernet ports with non-blocking wise speed performance
n 8 K MAC addresses
n 208KB on-chip frame buffer
n Supports Jumbo frame support, up to 9K
n Broadcast/Multicast Storm Suppression
n Port Mirroring
VLAN
n Port-base VLAN
n IEEE802.1q tag-base VLAN, up to 256 active VLANs
n Q-in-Q is an efficient method for enabling Subscriber Aggregation
VSM (Virtual Stacking Management):
n Up to 16 switches can be managed via Single IP limited to any specific Ruby-Tech models.
n Virtual stacking, no extra stacking hardware is required
n Distributed stacking, no physical central wiring closet is needed
Qos
n Supports Layer 4 TCP/UDP Port and ToS Classification
n Supports 802.1p QoS with two level priority queue
n Supports priority in a Q-in-Q tag
Bandwidth Control
n Supports bandwidth rating per port ingress and egress rate limit 1000Mbps with 1Mbps
Protocol
LACP
n Port trunking with 6 trunking group
n Up to 6 ports for each group
GVRP/GARP
n 802.1q with GVRP/ GARP
Multicasting
n Supports IGMP snooping including active and passive mode
STP/RSTP
n 802.1d/1w
Network Security
n 802.1x access control
n Management Access Policy Control (L2 ACL)
Snmpv1,v2c Network Management
RFC 1213 MIB (MIB-II)
RFC 1757 RMON MIB
Interface MIB
Statistics Group 1
Address Translation MIB
History Group 2
IP MIB
Alarm Group 3
ICMP MIB
Event Group 9
TCP MIB
RFC 1493 Bridge MIB
UDP MIB
RFC 1643 Ethernet MIB
SNMP MIB
Enterprise MIB

LED Description

LED
Color
Function
Global
POWER
Green
-Lit when +5V power is coming up
Global
CPU
Green
-Blinks when CPU is activity
Port 1-12
LINK/ACT
Green
-Lit when connection with remote device is good
-Blinks when any traffic is present
Port 1-12
10/100/1000Mbps
Green /Amber
-Lit Green when TP link on 1000Mbps speed
-Lit Amber when TP link on 100Mbps speed
-Off when 10Mbps or no link occur
Port 11,12

-SFP GreenLit when SFP connection with remote device is good
-Blinks when any traffic is present

Diagnostic LED:
System LED
Power
10/100/1000M TP Port Per Port LED
Link/Act, 1000/100Mbps
Gigabit SFP Module LED
SFP

Network Interface
Configuration
Connector
Port
10/100Mbps TP Jack (RJ-45)
TP(RJ-45)
1 to 12
1000Mbps SFP Fiber Module Dual Media Auto Detection
SFP
11, 12

Cable and Maximum Length:
TP
Cat. 5 UTP cable, up to 100m
1000Base-SX SC M-M
Up to 220/275/500/550m, which depends on Multi-Mode Fiber type
1000Base-LX SC S-M
Single-Mode Fiber, up to10/30/50Km
1000Base-LX WDM SC S-M
Single-Mode Single Fiber, Bidi 20Km

Hardware Spec.
Feature
Detailed Description
Power Supply
100~240 V, 50~60 Hz, 200W or 150W
Total Power for PoE
185W or 130W
Ambient Temperature
0 to 40 C
Weight
3kg
Safety
Comply with FCC Part 15 Class A & CE Mark Approval
Humidity
5% to 90%
Dimensions
44(H) x 442 (W) x 209 (D) mm

Packing Information
Carton Dimensions (mm)
pcs/Carton
N.W (KG)
G.W (KG)
530x512x345
5
19.5
20

Order Information
PSGS-2112CF
12-Port GbE L2 Managed PoE Switch with 2 SFP Dual Media (185W)
PSGS-2112C
12-Port GbE L2 Managed PoE Switch with 2 SFP Dual Media (130W)
SFP.LC
1000Base-SX GE SFP Fiber Module, LC Multi-Mode 850nm
SFP.LC.M2
1000Base-SX GE SFP Fiber Module, LC Multi-Mode 1310nm 2km
SFP.LC.S10
1000Base-LX GE SFP Single-Mode 10Km Fiber Module 1310nm
SFP.LC.S30
1000Base-LX GE SFP Single-Mode 30Km Fiber Module 1310nm
SFP.L5.S50
1000Base-LX GE SFP Single-Mode 50Km Fiber Module 1550nm
SFP.BL5.S10
1000Base-LX GE SFP BiDi_LC 10Km Module Single Fiber 1550nm, Type 1
SFP.BL3.S10
1000Base-LX GE SFP BiDi_LC 10Km Module Single Fiber 1310nm, Type 2
SFP.BL5.S20
1000Base-LX GE SFP BiDi_LC 20Km Module Single Fiber 1550nm, Type 1
SFP.BL3.S20
1000Base-LX GE SFP BiDi_LC 20Km Module Single Fiber 1310nm, Type 2

Aftur í vörur Panta vöru

a